Minn Kota 3 1/4" Motor Rebuild Kit

Product Description

Minn Kota motor rebuild kit for most 3 1/4" lower units.

 For use in 28 through 44 pound thrust motors.

***Be sure to check your application for proper fit!*** Motor diagrams available here   -->Minn Kota Diagrams<--

Minn Kota 3 1/4" Motor Rebuild Kit Contains:

• 1x 738-030 Brush Plate (#11 on diagram)
• 2x 188-052 Brush w/lead (#9 on diagram)
• 2x 975-032 Brush Spring (#14 on diagram)
• 1x 140-010 Bearing(#8 on diagram)
• 1x 2883460 Seal Kit (INCLUDES ALL 6 SEALS)
• 1x 788-015 Retaining Ring (#2 on diagram)
• 1x 990-067 Steel Washer (#22 on diagram)
• 2x 990-070 Nylatron Washer (#23 on diagram)

• Complete Pro-Series Rebuild Kit for Minn Kota 3-1/4" Trolling Motors

  Bring your trusted Minn Kota trolling motor back to factory-spec performance and ensure years of future reliability with this comprehensive motor rebuild kit. Designed specifically for Minn Kota's ubiquitous 3-1/4" diameter lower units (motor housings), this kit contains all the essential, high-wear components needed to perform a complete and professional overhaul.

  Over time, the internal components of even the most reliable trolling motors can wear down. Brushes lose material, seals can become brittle and fail, and bearings can develop play, all of which leads to reduced power, increased noise, and the potential for catastrophic water intrusion. This rebuild kit addresses all of these failure points in one convenient package, providing everything you need to restore the heart of your motor.

  By rebuilding the motor, you can fix issues like slow or inconsistent speeds, grinding noises, and intermittent operation. It is the perfect solution for routine preventative maintenance on a motor with high hours or for bringing a non-functioning motor back to life, saving you the significant cost of a brand-new unit.

  ---

  Compatibility:

  This rebuild kit is designed exclusively for Minn Kota freshwater and saltwater trolling motors that utilize a 3-1/4" outside diameter lower unit housing. This is one of the most common motor sizes produced by Minn Kota over the years.

  The kit is compatible with, but not limited to, the following Minn Kota motor models:

  All Terrain (AT) Series:

  • 30AT, 33AT, 36AT, 40AT, 42AT, 44AT

  Edge Series:

  • 40, 45

  Endura & Endura C2 Series:

  • 30, 34, 36, 38, 40, 42, 45

  Endura Pro Series:

  • 32, 38

  PowerDrive & PowerDrive V2 Series:

  • 36, 40, 42

  Classic Series:

  • 28, 36, 40

  Other Models:

  • 35A, 35TA, 65, 65TA
  • 365T, 365TA
  • Spider 48
  • Various other models with thrust ratings typically between 28 lbs and 45 lbs.

  Important Note on Verification: The most reliable way to confirm compatibility is to measure the outside diameter of your motor's lower unit (the "can" at the bottom). If it measures 3-1/4 inches, this kit is designed for your motor. It is not compatible with larger motors (e.g., 3-5/8" or 4" diameters) found on higher-thrust models. Always verify your motor size before ordering to ensure a perfect fit and a successful rebuild.