Replacement clamp screw kit for Minn Kota trolling motors.
This is an aftermarket upgrade for your motor. Made from zinc plated steel rods, these clamp kits use the stock Minn Kota clamp washer # 2011710 so you can continue to replace the individual parts if they wear out or get damaged. Fits transoms from 1 1/2" to 3 1/4" thick.
This kit is a direct replacement of Minn Kota #2881380
To install, remove the old clamp screws on your mount by cutting them off. Screw in the new ones and add the washer and screw...done!
- Hacksaw or other to cut old screws off
- 4mm allen wrench (hex key) to tighten new washer retaining screw