Product Description
Mitchell 84297 Bail Wire Assembly
Product ID: 84297 Brand: Mitchell
Essential Repair for "60" Size Graphite Series
Restore the flawless line management of your large-capacity Mitchell spinning reel with the Mitchell 84297 Bail Wire. Designed specifically for the "60" size family of graphite and rear drag reels, this genuine replacement component is vital for consistent casting and retrieval. A bent bail wire is the primary cause of bail spring failure and uneven line spooling. Replace your damaged assembly with this factory-correct wire to ensure your bail trips automatically and your line lays perfectly every time.
Compatibility & Fitment
This part is the specific bail wire for the size 60 (Heavy Freshwater/Light Saltwater) models in the graphite and rear drag series. Please verify your reel model against the list below.
-
Mitchell 1160 RD
-
Mitchell 1160 G
-
Mitchell 2160 RD
-
Mitchell 2160 G
-
Mitchell 2560 G
(Note: "RD" denotes Rear Drag; "G" denotes Graphite. This wire is contoured for the wide rotor geometry of the 60-series.)
Part Specifications
-
Part Number: 84297
-
Alternate Part Number: MIT-84297
-
Material: High-strength stainless alloy
-
Finish: Matte Black / Dark Grey (Corrosion Resistant)
-
Position: Rotor Assembly
-
Function: Line pickup and automatic retrieval engagement
Installation & Maintenance Recommendation
Installing a new bail wire is the perfect time to service the pivot points that may have caused the original damage. Stiff bail movement often leads to anglers forcing the bail, resulting in bent wires.
Recommended Lubrication: We recommend using Deuthlon technology for the best results:
-
Deuthlon Semi-Fluid Grease: Apply to the internal bail spring and trip lever. This prevents rust and ensures the bail snaps shut with authority.
-
Deuthlon Cast Lube (Ceramic): Apply a drop to the line roller bushing and the bail hinge screws. This high-performance oil repels dirt and ensures friction-free rotation.
Schematic Verification
To ensure 84297 is the correct part for your specific reel generation (as some model numbers span multiple production years), please reference the official PDF part diagrams. www.reelschematic.com
Tech Tip: When installing, check the alignment of the bail wire with the screw holes before tightening. The wire should line up naturally. If you have to squeeze it significantly to make it fit, the wire may be distorted or the rotor arms may be out of true.
Why Choose This Part?
-
OEM Specification: Designed for the exact width and angle of the 1160/2160/2560 rotors.
-
Line Safety: Smooth surface finish prevents abrasion on heavy monofilament and braid.
-
Durability: Built to withstand the higher drag pressures and heavier lines used with 60-size reels.
