Product Description

DAM Quick 110-525 R/S Plate - SLS 5

Protect the powerhouse internals of your surf reel with this genuine DAM Quick Right Side Plate.

The Right Side Plate (R/S Plate) is the heavy-duty cover for the main gearbox of the DAM Quick SLS 5. As the largest reel in the series, designed for surf casting and big game, the SLS 5 relies on this plate to maintain rigid alignment of the main drive gear under heavy drag loads. A cracked or warped side plate can lead to gear misalignment, water intrusion, and catastrophic failure during a fight. This authentic replacement restores the reel's structural integrity and weather sealing.

Product Features

• Heavy-Duty Construction: Molded from reinforced material to withstand the high torque and stress of the SLS 5.

• Precision Seal: Engineered to mate perfectly with the reel body, preventing saltwater, sand, and grit from entering the gearbox.

• Gear Alignment: Provides the critical bearing support needed to keep the massive main gear running true.

• OEM Restoration: Matches the original factory finish and geometry for a seamless repair.

Model Compatibility

This part is verified to fit the following DAM Quick spinning reel models:

• DAM Quick SLS 5

Note: This side plate is unique to the massive SLS 5 frame. It is not interchangeable with the smaller SLS 0, 1, 2, 3, or 4 models.

Part Specifications

• Part Number: 110-525

• Alternate Part Number: 110525

• Part Description: Right Side Plate / Body Cover / Gearbox Cover

Schematic Reference

To confirm the location of body screws and the bearing assembly within this plate, please consult the service diagrams.

• View the specific schematic for your reel at www.reelschematic.com

Installation Notes

Replacing the side plate on the SLS 5 is a significant maintenance task.

1. Remove the heavy-duty handle and all retaining screws from the side plate. Note that screw lengths often differ.

2. Gently pry the old plate off. Be careful not to damage the gasket (if present) or lose the shims located on the drive gear shaft.

3. Clean the rim of the main body housing thoroughly to remove salt buildup and old grease.

4. If the new plate does not come with a bearing/bushing, carefully transfer the one from the old plate.

5. Apply a thin bead of marine grease to the mating edge of the new 110-525 plate for extra water resistance.

6. Align the plate and tighten the screws evenly to prevent warping.